Lip part : This is of a type having seal lip without spring. Assmbled types available such as S type and T type ones : This cannot be used for extremely great Circumferential velocity and eccentricity.
Fiting part:GM(metal), G type(rubber)

Grease and / Dust seals / (Not usable for a point with pressure applied)

Lip part : This is of a type consisting of seal lip and dust lip without spring. Filling grease in between these lips enables it to be used even in a non- lubrication state. It cannot be used for extremely great circumferential velocity and eccentricity.
Fitting part : SM type(metal), S type(rubber)

Eneral seal for dust-free oil or water / (Pressure is MAX 0.3kg/㎟)

Lip part : This is of a type having seal lip with spring and is used most commonly Fitting part : SM type(metal), S type(rubber)

General seal for oil or water with dust / (Pressure is MAX 0.3kg/㎠)

Lip part : This is of a type having seal lip and dust lip with spring. Filling grease in between these lip enables it to be used enve in a non- lubrication state.
Fitting part : DM type(metal), D type(rubber)

Seal to be used in the case of separating two fluids on oil, water, etc.

Lip part : This is of a type with 2 seal lips with spring faced in oppsite direction from each other. Such a type with 2 S type oil seals assembled in opposite direction is available. It is used for very small fluctuating pressure(negative pressure~positive pressure), eg 2-cycle engine and fuel pump.
Fitting part: DM type(metal), D type(rubber)

Seal for medium pressure such as oil or water (Pressure is based on of circumferential velocity of 3m/sec. Up to instantaneous pressure of 0.3kg/㎠ is premitted)

Lip part : This is of a type consisting of seal lip and dust lip with spring. It is designed to minimize lip deformation under high pressure in order to improve pressure resistance.
Fitting part : Rubber

Seal for high pressure such as oil or water/ (Pressure is based on of Circumferential velocity of 3m/sec. Up to instantaneous pressure of 10kg/㎠ is premitted.)

Lip part : This is of a type having seal lip and dust lip with spring. It is structured to reinforcing ring to minimize lip deformation under high pressure.

Seal for reciprocal movement of oil or water (Pressure is based on of 40mm dia. Shaft, circumferential velocity of 0.6m/sec. MAX 3kg/㎠ is permitted)

Lip part : This is of a type consisting of seal lip and dust lip with spring. It is designed to minimize lip deformation under reciprocal movement
Fitting part: DM4 type(metal), D4 type(rubber)